GE GFDR485EF Technical Service Manual page 49

Water Valve
Retainer
Steam Elbow
Mist Nozzle
The mist nozzle is located inside the dryer on the left
side of the rear bulkhead. The mist nozzle consists
should become plugged or restricted, it should not
be cleaned. Replace a plugged or restricted misting
nozzle.
Nozzle Holder
Nozzle Holder Removal
1. Disconnect the steam tube from the water valve.
2. Remove the nozzle retainer by twisting slightly
counter-clockwise.
Water Valve
Operating Voltage: 120 VAC
Resistance
Water Valve Removal
1. Disconnect power and water from the unit .
2. Remove the control panel.
See Control Panel Removal on page 20.
3. Remove the top panel.
See Top Panel Removal on page 24.
4. Disconnect the water valve wire harness and the
water line.
Steam Components
Steam Tube
Nozzle Holder
Mist Nozzle
5. Remove the 1/4 in. hex screw that holds the wa-
ter valve in place.
6. Slide the water valve slightly left to remove.
49
1/4" hex