Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Porsche MCB36E1
Summary of Contents for Porsche MCB36E1
- Page 1 Porsche Mobile Charger Good to know – Driver’s Manual...
- Page 2 Because of different legal requirements in individual countries, the equipment in your vehicle may vary 70435 Stuttgart Germany from what is described in this manual. If your Porsche Germany is fitted with any equipment not described in this Driver’s Manual...
- Page 3 About this Driver's Manual 1. If an instruction comprises several steps, these are numbered. Warnings and symbols 2. Instructions that you must follow on the cen- Various types of warnings and symbols are used in tral display. this Driver's Manual. g Notice on where you can find further important Serious injury or death DANGER...
-
Page 4: Table Of Contents
Table of contents To the Driver's Manual Key to pictograms....... 3 Security Safety instructions. -
Page 5: To The Driver's Manual
To the Driver's Manual To the Driver's Manual Risk of electric shock due to uninten- Key to pictograms ded use. Depending on the country, various pictograms may be attached to the charger. Observe the operating instructions Operate the charger within a temperature provided, particularly the warnings range from -30 °C to +50 °C. -
Page 6: Security
Driver’s Manual. installation with an energy management system. – The charger should preferably be operated in earthed mains supply systems. The protective conductor must be properly installed. 1. Time of printing. Further information is available from your Porsche partner. -
Page 7: Intended Use
Porsche recommends that you have electrical installations used for charging checked regularly by a qualified electrician. Ask a qualified electri- cian which inspection intervals are appropriate for your installation. -
Page 8: Scope Of Supply
Scope of supply Scope of supply Fig. 1: Overview of charger Supply cable (detachable from control unit) Plug of the supply cable on the control unit. Power plug for connecting to the mains supply Vehicle plug (connector plug for the vehicle) Vehicle cable (permanently installed on control unit) Control unit... -
Page 9: Overview
Overview g Refer to chapter "Control unit status indicators and Overview error messages" on page 19. Charger control unit Fig. 2: Control unit ON/OFF button with indicator light and addi- tional charging current limiting function Power supply/domestic connection indicator light Vehicle indicator light Control unit indicator light Reset button with indicator light The operating state of the control unit and charging... -
Page 10: Requirements And Conditions
Requirements and conditions Requirements and conditions – Install the basic wall mount so that it is not near pathways and the charging cables do not cross Selecting the installation location any pathways. – Electric shock, fire Install the basic wall mount so that the distance DANGER between the plug and the socket does not ex- ceed the length of the available supply cable. -
Page 11: Installing
Installing Installing Installing the connector fastener Installing the wall mount Installing the basic wall mount Fig. 5: Drilling dimensions Fig. 4: Distance between wall mount and connector fastener 1. Remove the connector fastener 1 (Fig. 5) from the cover 2 (Fig. 5). When installing the connector fastener, ensure a dis- 2. - Page 12 Installing Attaching the control unit to the wall mount Fig. 6: Attaching the control unit 1. Route the vehicle cable through the lower open- ing of the basic wall mount, place the bottom of the control unit on the locking tab and push back to engage.
-
Page 13: Set Up
Set up Set up Country Supply cable Vehicle charging cables and supply Russia, Ukraine 5, 6, 7, 8, C cables Abu Dhabi, Israel, Sin- 5, 6, 7, 8 Information on vehicle charging cables gapore and plugs Different vehicle charge ports A and vehicle plugs B Approval of supply cables in different countries (ex- are available depending on the vehicle equipment. - Page 14 WCZ8 15 A WCZ8 20 A NEMA 6-50 CEE 7/5; CEE 7/7 Type E/Type F (shockproof) IEC 60309-2 CEE 230 V/16 A 6 h BS 1363 Type G 1. Time of printing. Further information is available from your Porsche partner.
- Page 15 Set up NEMA 6-50/NEMA 14-50 (additional infor- Requirements for the mains socket mation) Unsuitable mains sockets DANGER M09A-15 Information Type I An unsuitable mains socket can cause a short circuit, Scope electric shock, explosion, fire, or burns. This usage recommendation only applies to regions Only use only a type of mains socket that is with the NEMA 6-50/NEMA 14-50 standard.
- Page 16 Use a NEMA 3R rainproof enclosure. Contact surface covers the full height of the plug- in contact Small contact surface between terminal screw and wire. Wide contact surface between terminal plate and wire 1. Time of printing. Further information is available from your Porsche partner.
- Page 17 Set up Disconnecting the supply cable Securing supply cables and plugs Fig. 7: Plug of the supply cable connection on the control unit. Fig. 8: Disconnecting cables Fig. 9: Connecting cables and securing plugs The plug of the supply cable connection can be re- b Charging of the high-voltage battery has ended b Lever A (Fig. 9) is closed.
-
Page 18: Operating
"Technical Data" on page 28. – Temperature of the high-voltage battery and control unit – Passenger compartment precooling/heating ac- tivated 1. Time of printing. Further information is available from your Porsche partner. - Page 19 DANGER cuit, fire, explosion the full charging power not being available. Further 3. Charging starts automatically. information is available from your Porsche partner. �� The indicator light on the ON/OFF button Using the charger without active protective conduc- pulses green.
- Page 20 Operating Reset is off. 1. Press the ON/OFF and Reset buttons. After the control unit indicator light flashes 6 times, release the buttons. 2. After 1 second, press the ON/OFF and Reset buttons again. After the control unit indicator light flashes 6 times, release the buttons.
-
Page 21: Control Unit Status Indicators And Error Messages
Control unit status indicators and error messages Control unit status indicators and error messages Indicator lights Meaning Remedy ON/OFF lights up green. The charger is ready for charging, but no Start charging process. g Refer to chapter "Starting charging" on page 17. charging takes place. - Page 22 Control unit lights up yellow. If the fault persists, have the control unit checked by a Reset is off. specialist dealer/Porsche partner. ON/OFF lights up red. The power plug is overheated. The fault is automatically reset and charging resumed once the power plug has cooled down.
- Page 23 Power supply/domestic connection is off. The charging process is interrupted. If the fault persists, have the vehicle checked by a spe- Vehicle flashes yellow. cialist dealer/Porsche partner. Control unit is off. Reset is off. ON/OFF lights up red. The supply or vehicle cable is defective.
- Page 24 Control unit is off. rupted the charging process. Only earthed mains supply systems: Have the control unit Reset is off. checked by a specialist dealer/Porsche partner and the power supply/domestic connection checked by a quali- fied electrician. ON/OFF lights up red.
- Page 25 Power supply/domestic connection lights up If the fault persists, have the control unit checked by red. The charging process is interrupted. a specialist dealer/Porsche partner and the power sup- ply/domestic connection checked by a qualified electri- Vehicle lights up red. cian.
- Page 26 Control unit status indicators and error messages Indicator lights Meaning Remedy ON/OFF is off. The indicator light in the ON/OFF button on Have the control unit replaced by a specialist dealer/Por- the control unit is defective. sche partner. Power supply/domestic connection lights up red.
-
Page 27: Transport
Transport Transport Securing the Transport Case (e.g. Panamera 4 E-Hybrid) Unsecured load WARNING An unsecured, incorrectly secured or incorrectly posi- tioned charger can slip out of place and endanger the vehicle occupants during braking, acceleration, direction changes or in accidents. Never transport the charger unsecured. -
Page 28: Cleaning And Maintenance
Cleaning and maintenance Cleaning and maintenance Check the charger for damage and soiling at regular intervals and clean it if necessary. Electric shock, fire DANGER Risk of serious or fatal injury due to fire or electric shock. Never immerse the charger or plugs in water or spray them directly with water (e.g. -
Page 29: Disposal
Electrical/electronic devices must be handed in at a collection point or waste management facility. Do not throw electrical/electronic devices in with household waste. Dispose of electrical/electronic devices in ac- cordance with the applicable environmental pro- tection regulations. If you have questions about disposal, contact a Porsche partner. -
Page 30: Technical Data
Technical Data Technical Data Electrical data MCB36E1 MCB72E2 MCB72E1 MCB96J1 MCB11E3 MCB36S1 MCB72S1 MCB36J1 Power 3.6 kW 7.2 kW 7.2 kW 9.6 kW 11 kW Rated current 16 A, 1-phase 16 A, 2-phase 32 A, 1-phase 40 A, 1-phase 16 A, 3-phase Mains voltage 100 V –... -
Page 31: Production Information
Technical Data Mechanical data Weight of control panel 2.4 - 3.5 kg Wall mount dimensions 136 mm x 391 mm x 76 mm (width x height x depth) Weight of wall mount approx. 450 g Cable guide dimensions 127 mm x 139 mm x 115 mm (width x height x depth) Weight of cable guide approx. -
Page 32: Importers
Calcot, Reading, Berkshire frastructure (e.g. VDE 0702), please re- RG31 7SE fer to https://www.porsche.com/international/ac- United Kingdom cessoriesandservice/porscheservice/vehicleinforma- tion/documents/ or contact a Porsche partner. Russland Importers Porsche Russia Ленинградское шоссе дом 71A, строение 10 Abu Dhabi: Ali & Sons Co. L.L.C 125445, Москва, Россия... -
Page 33: Index
Index Index Installing the connector fastener....9 Intended use........5 Vehicle charging cable Cable and plug types.