Appendix A: Troubleshooting & Frequently Asked Questions - Planet Networking & Communication HZS-532E-DE User Manual

Appendix A: Troubleshooting & Frequently
This difference between Z-Wave
and ZigBee
How to reset the HZS-530 Series
Repeater Function
Overload Protection
How to view the energy
consumption report
Asked Questions
Features
The frequency is different between Z-Wave and ZigBee. ZigBee
is 2.4GHz and Z-Wave is about 900MHz.
The outdoor distance is different. ZigBee is 10~75 meters and
Z-Wave is about 30 meters.
Z-Wave Device Installation
Press the Program Switch to power on (plug-in) and hold for 5
seconds before releasing the switch. Only use this procedure when
the primary controller is lost or otherwise inoperable.
You could install the HZS-530 Series to extend the frequency range
of Z-Wave. The Energy Meter can act as a signal repeater to
enhance the Z-Wave wireless communication range. For example,
the HAC-1000 (Control Gateway) is installed on the second floor to
control over the HZS-300 (4-in-1 Sensor) installed on the first floor,
but the Z-Wave frequency is weak. Thus, HZS-530 Series can be
installed in between the second floor and the first floor to solve the
problem.
If load is more than 10.5A for all others, then relay will automatically
cut off. To restore the relay, please power off and power on the
device again.
1) You could install Cloud Home App with PLANET HAC-1000,
and check the report about the voltage, current, wattage and
total KWh usage.
2) Go to the report of the HAC-1000 and check the voltage,
current, wattage and total KWh usage.
- -
28
Z-Wave Smart Energy Meter
HZS-530 Series