Table of Contents
Advertisement
Mount Transducer So it Will Scan Properly
Rear
View
Side
view
It is important to note that if the vertical scanning
transducer is not mounted so that the fore and aft
direction is parallel to the surface, then the
forward-looking display may be distorted where
flat bottoms appear to be slanted upwards or down-
wards. After mounting the transducer and actually
Waterline
using the PC/View on the water, you may need to
readjust the transducers' mounting for optimum
performance.
Refer to the discussion of Transducer Mount Cor-
Transducer
rections on page 24.
must be
mounted
vertically
Waterline
Flat area on top of
transducer must be
level with waterline
12
NOTE
The flat top of the transducer must be
parallel to the water line. This will not
necessarily be parallel to the boat's hull.
Advertisement
Table of Contents
