Bosch SHX78B75UC Use And Care Manual page 52

en-us Troubleshooting
Issue
Special salt refill in-
dicator lights up.
Refill indicator for
special salt does not
light up.
Refill indicator for
rinse aid lights up.
Refill indicator for
rinse aid does not
light up.
All LEDs light up or
flash.
Water is left in the
appliance at the end
of the program.
Appliance cannot be
switched on or oper-
ated.
52
Cause and troubleshooting
Sensor does not detect special salt tablets.
Do not use special salt tablets.
▶
Water softening system is switched off.
Adjust water softening system
▶
No rinse aid.
Add Rinse aid → Page 25 .
1.
Set the amount of rinse aid to be dispensed.
2.
→ "Setting the amount of rinse aid", Page 26
Rinse aid system is switched off.
Set the amount of rinse aid.
▶
Electronics have detected a fault.
Press the main switch button for approx. 4 sec-
1.
onds.
→ "Controls", Page 13
The appliance is reset and restarted.
If the problem occurs again:
2.
Switch off the appliance.
‒
Unplug the power plug or switch off the cir-
‒
cuit breaker in the fuse box.
Wait at least 2 minutes.
‒
Switch on the circuit breaker in the fuse box
‒
or plug in the power plug.
Switch on the appliance.
‒
If the problem occurs again:
3.
Contact customer service.
‒
→ "Customer Service", Page 56
Filter system or area under the filters is blocked.
Clean the Filters → Page 41 .
1.
Clean the Wastewater pump → Page 54 .
2.
Program has not yet ended.
Wait until the program ends or terminate the
▶
program with Reset.
→ "Terminating the wash cycle", Page 33
▶
Software update is taking place.
Wait until the software update has finished.
▶
Appliance functions have failed.
Pull out the power cord plug or switch off the
1.
breaker.
Wait at least 2 minutes.
2.
Connect the appliance to the power supply.
3.