Mount Check-Mate 450, 800,
1000, and 2100 Pumps
NOTE:
The Pump Mounting Chart on page x lists the parts
necessary to mount Check-Mate 450, 800, 1000, and
2100 Pumps on this ram. Installing other pumps on
the ram may require alternate parts. For information,
contact your Graco distributor.
This installation requires Mounting Kit 222776 and
224829 which must be ordered separately. See
Accessories on page 24.
1. Position the mounting brackets (42) so that the top
of the pump will clear the support beam (4).
2. For President and Monark Check-Mate 450 Pumps
only, install the mounting plate (CA) from kit 224829
onto the mounting brackets (42) using four screws
(CB) and lockwashers (CC). See F
NOTE: The plate (CA) is oriented differently for the
President than for the Monark.
For President Pumps
CB
CC
CJ
CL
For Monark Pumps
CB
CC
CA
F
. 7
IG
3A0233B
3. Attach the motor to the mounting brackets (57) or
4. Place the gasket (CK) from Mounting Kit 222776 on
. 7.
IG
F
IG
CA
‡
mounting plate (CA) with the fasteners supplied (‡),
as applicable.
the ram plate (114). See F
ing bracket setscrews (43), and carefully lower the
pump onto the gasket and plate. Secure the pump's
intake flange (CN) to the plate with the screws (CL)
and lugs (CM) included in the mounting kit.
CL
CM
. 8
Installation
. 8. Loosen the mount-
IG
CN
CK
114
02938
11