Ryobi RLT-300 Owner's Operating Manual page 8

Electric line trimmer

Warning!

do not connect the machine to the mains socket before it is completely assembled.

FITTInG AuXIlIArY HAndlE

noTE:This may already be pre-fitted to the

trimmer. However the following instructions

give full assembly details.

1. Locate the auxiliary handle (3) to the bracket.

Note its orientation.

2. Insert the bolt through the bracket and the

handle and screw into the captivated nut.

Tighten using the auxiliary handle locking knob

(4).

FITTInG GuArd

1. Fit the safety guard (9) into the slot on motor

housing, and then turn the safety guard till the

screw holes on the safety guard and motor

housing (8) are aligned.

2. Secure the safety guard onto the motor housing

with screws provided.

AdJuSTInG AuXIlIArY HAndlE (Fig. 3)

The angle of the auxiliary handle can be fully adjusted

in your most suitable position.

1. Loosen the auxiliary handle locking knob (4), and

adjust the angle of the auxiliary handle in the

direction of the shaft and also in a circumferential

direction of the shaft.

2. Turn the knob until the handle is securely tightened

note: For trimming, adjust the handle upward. For

edging adjust it downward.

(Fig.1)

(Fig.2)

ASSEmBlY

Fig. 1

Fig. 2

Fig. 3