HP 15-fb0 Series Maintenance And Service Manual page 40

Table 5-2 Memory module descriptions and part numbers
Description
8 GB, DDR4-3200
4 GB, DDR4-3200
Before removing the memory, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Disconnect the battery cable from the system board (see
If you are replacing a memory module, remove the existing memory module:
1. If present, pull the protective shielding up from the top and toward you to access the memory modules.
2. Spread the two retention clips outward (1) until the memory module tilts up at a 45° angle, and then
remove the module (2). Use the same procedure to remove all memory modules.
IMPORTANT:
Do not touch the components on the memory module.
To protect a memory module after removal, place it in an electrostatic-safe container.
To install a memory module:
1. Align the notched edge of the module with the tab in the slot (1), and then press the module into the slot
at an angle until it is seated (2).
34 Chapter 5 Removal and replacement procedures for Customer Self-Repair parts
Bottom cover on page
To prevent damage to the memory module, hold the memory module by the edges only.
Preparation for disassembly on page
36).
Battery on page
Spare part number
L46598-001
L83673-001
32).
38).