Troubleshooting - Black & Decker ST7700-CA Instruction Manual

PrOBlEM
Trimmer runs slowly.
Trimmer will not start.
Overfeeding
Line unravels when cap or spool is removed.

TrOUBlEshOOTing

sOlUTiOn
• Unplug trimmer.
• Check that the spool housing can rotate freely. Carefully
clean it if necessary.
• Check that the cutting line does not protrude more
than approximately 4-13/16 inches (122mm) from the
spool. If it does, cut it off so that it just reaches the line
trimmingblade.
• Plug trimmer into a working outlet.
• Replace circuit fuse. (If the product repeatedly causes the
circuit fuse to blow, discontinue use immediately and
have it serviced at a BLACK+DECKER service center or
authorized servicer.)
• Have cord or switch replaced at a BLACK +DECKER Service
Center or Authorized Servicer
• Make sure you are using 0.065 inch (1.65 mm) diameter
ROUND line.
• Ensure you are cutting with the tip of the line (7 inches
(177.8mm) from the spool).Use the edge guide if needed
to ensure proper space is maintained.
• Ensure you are not exceeding a 10° angle.
• Make sure to park the lines in holding slots (figure S)
before removing.
Imported by Black & Decker (U.S.) Inc.,
701 E. Joppa Rd.
Towson, MD 21286
BlackandDecker.com
1-800-544-6986
English
9