Table of Contents
Advertisement
home, or by returning to home if starting from another location,
such as where it stopped when the last printing job was com-
plete.
When printing is complete, the print head remains where it
stopped with a low hold energy applied to the print head. Fur-
ther printing activity begins from this stopped point. If there is
no activity after ten seconds, the print head returns to its home
position and is no longer held in place. If the print head is
moved from this position, the printer will relocate to home posi-
tion before printing again.
The head gap adjuster is near the printer mechanism on the side
opposite the green thumb wheel. The print head adjuster has
five notches between the print head and the platen for different
paper thicknesses.
Verify the thickness of the paper loaded into the printer.
S If you are using single-sheet forms, set the head gap adjuster
to the third notch away from the paper.
S If you are using multiple-sheet forms (2-ply or 3-ply), set the
head gap adjuster to the fourth notch away from the paper.
S If you experience frequent head jams, set the head gap adjust-
er to the fifth notch away from the paper. This may stop the
head jams.
S If the 2-ply and 3-ply paper have light printing, setting the
gap adjuster to a closer setting darkens the print.
1
5
12
PK80F 80-Column Fixed Mount Printer Quick Start Guide
Advertisement
Table of Contents
