Table of Contents
Advertisement
Follow the 'Storing Radio Presets' guide in the 'Operating Instructions' section for full details on storing presets.
5. INPUT SOURCE BUTTONS (DIGITAL INPUTS D1, D2, D3 for AXR100 only) - Press the relevant source button to select the desired input source.
Note: There will be no sound from the receiver if the correct input source button isn't selected.
6. PRESET BUTTONS - Used for AM/FM modes. The preset buttons are used to select user-stored station presets.
Pressing a preset button once will select one of the first 5 presets.
Pressing and holding will select the later 5 presets.
These presets are stored separately for each waveband i.e. there are 10 for FM and 10 for AM. Press the FM/AM button to switch between bands
and sets of 10 presets.
Follow the 'Storing Radio Presets' guide in the 'Operating Instructions' section for full details on storing presets.
Note: As well as these 10 per band available directly from the front panel buttons, a further 5 presets (11-15) per band can also be accessed by using
the 'Skip/Scan' buttons to cycle through all 15 presets.
7. DISPLAY - Used to display information such as the selected input source, volume and tone/balance levels. When the FM or AM tuner input is selected,
the radio frequency or RDS station name will be displayed.
Note: When first purchased, the display will have a protective film over the top. Peel this off for a clear display.
8. SPEAKER A/B BUTTON - The Speaker A/B button toggles between the two sets of loudspeaker terminals. The options are speaker A only, speaker B
only, speaker A and B together, and both sets of speakers off.
Note: 'Speaker off' is different to the mute function, as the Rec Out and Headphones outputs are still enabled.
9. MENU BUTTON - Pressing this once will select the Bass option. Pressing a second time will select the Treble option and pressing a third time will
select the Balance option. When one of these options is selected, the volume control will adjust the level.
If nothing is pressed for a while, the source will be displayed and the volume control will go back to controlling the volume level.
Note: Any adjustments to the Bass, Treble and Balance settings are saved when the unit is switched off and back on again.
10. INFRARED SENSOR - Receives IR commands from the supplied remote control. An unobstructed line of sight between the remote control and the
sensor is required.
11. VOLUME CONTROL - Use to increase or decrease the level of the sound from the outputs of the unit.
This controls the volume level of the loudspeakers, Sub-out and headphones.
Note: It does not affect the level of the 'Rec Out' output, as this has a fixed level.
The volume control will also change the level of bass, treble and balance in the menu options.
12. AUX INPUT SOCKET - This source input allows you to connect a portable audio device, such as a smart phone, directly into the front of the unit
using a 3.5mm stereo-jack. Once plugged in, this input is automatically selected.
7
Advertisement
Table of Contents
