Roland JUPITER-8 User Manual page 9

Parameter Value Explanation
Adjusts the amount by which the LFO
FILTER MOD
0–100
modulates the cutoff frequency.
Adjusts the amount by which the keyboard
pitch affects the cutoff frequency (key follow).
FLT KEY FOLLOW 0–200
With smaller values, the cutoff frequency
becomes lower as you play higher notes.
AMP LEVEL 0–127 Adjusts the volume of the tone.
Uses the LFO to vary the AMP volume
AMP MOD-STEP 0–3 (tremolo effect). Higher values produce a
greater effect.
ENV1 ATTACK 0–1023 Specifies the ENV1 Attack time.
ENV1 DECAY 0–1023 Specifies the ENV1 Decay time.
ENV1 SUSTAIN
0–1023 Specifies the ENV1 Sustain level.
ENV1 RELEASE
0–1023 Specifies the ENV1 Release time.
Specifies the ENV1 key follow. If key follow is
ENV1 KEY FLW SW OFF, ON
on, ADR times become longer for lower notes
and shorter for higher notes.
ENV2 ATTACK 0–1023 Specifies the ENV2 Attack time.
ENV2 DECAY
0–1023 Specifies the ENV2 Decay time.
ENV2 SUSTAIN 0–1023 Specifies the ENV2 Sustain level.
ENV2 RELEASE 0–1023 Specifies the ENV2 Release time.
Specifies the ENV2 key follow. If key follow is
ENV2 KEY FLW SW OFF, ON on, ADR times become longer for lower notes
and shorter for higher notes.
Specifies the range of pitch change produced
BEND PITCH 0–1200
by pitch bend.
Specifies the range of filter change produced
BEND FILTER -63–+63
by pitch bend.
MODULATION Specifies the amount of LFO applied by
-63–+63
LFO modulation.
Turns portamento on/off. If this is on, the pitch
PORTA MODE OFF, ON will change smoothly from one note to the
next-played note.
Adjusts the time over which the portamento
PORTA TIME 0–1023
pitch change occurs.
Specifies the pitch change curve for portamento.
Change according to the original curve of
ORIGINAL
the model.
PORTA CRV
LINEAR Change in a linear curve.
EXP1 Change in a non-linear curve (gentle slope).
EXP2 Change in a non-linear curve (steep slope).
Specifies how notes are sounded.
POLY Polyphonic
KEY MODE
SOLO Monophonic
UNISON Unison
SL-UNISON Monophonic unison
Sets how much aftertouch changes the LFO
intensity.
AFT LFO -63–+63
* This is only enabled for keyboards with
Sets how much aftertouch changes the low-
pass filter intensity.
AFT FREQ
-63–+63
* This is only enabled for keyboards with
Sets how much aftertouch changes the tone
volume.
AFT LEVEL -63–+63
* This is only enabled for keyboards with
Adjusts the slight pitch drift that occurs when
PITCH DRIFT 0–255
notes are played on an analog synthesizer.
If this is "ON", the range of change for LFO
PARAM
OFF, ON RATE, CUTOFF, RESONANCE, and FILTER ENV
EXPANSION
DEPTH is wider than on the original model.
Simulates the changes that occur as a unit
CONDITION 0–100
ages.
aftertouch.
aftertouch.
aftertouch.
CC#
28
82
110
30
83
80
85
86
89
90
102
103
41
14
118
5
119
Parameter Guide
9