Using the JX-8P Model Expansion This manual explains how to use JX-8P Model Expansion with the JUNO-X. There are two ways to use JX-8P Model Expansion. In this manual, we explain how to do this via Roland Cloud Manager. Using Roland Cloud Manager...
Save the file (EXM003_JX8P.exz) to the root directory of the USB flash drive. If there is not enough free memory, you can uninstall Model Expansions that are already installed, and then install the JX-8P Model Disconnect the USB flash drive from your computer. Expansion.
A confirmation message appears. If you decide to cancel, press the [EXIT] button. When you want to import or install a JX-8P Model Expansion that has a To execute, use the [- VALUE +] knob to select “OK”, different user license from the Model Expansions already registered in and then press the [ENTER] (INIT) button.
Use the [ Ç SELECT É ] knob to select where to register the JX-8P. Tone name Use the [- VALUE +] knob to select “JX-8P”. Tone number If you want to save the setting, execute the System Write operation.
Section Controller Parameter Section Controller Parameter used with the used with the [SHIFT] button [SHIFT] button JX-8P TONE EDIT: PITCH Select PITCH ENV Select PORTA ON PORTA MODE PORTAMENTO JX-8P TONE EDIT: FILTER Select FILTER ENV TIME PORTA TIME...
Parameter Guide TONE Parameters TONE COMMON TONE JX-8P JX-8P Parameter Value Explanation Parameter Value Explanation (name) Tone name OSC1 RANGE 16’ , 8’ , 4’ , 2’ Specifies the octave of OSC1. Catg CATEGORY Selects the tone’s category. SAW, PULSE,...
Page 9
Parameter Guide Parameter Value Explanation Adjusts the sensitivity at which velocity AMP DYNAMICS 0–3 controls the AMP ENV depth. SINE, LFO WAVEFORM SQR, Specifies the LFO waveform. S&H LFO RATE 0–1023 Specifies the rate of the LFO cycle. Adjusts the time from when a key is pressed LFO DELAY TIME 0–1023 until LFO modulation starts being applied.