Three-Step Quick Start - JVC HR-V705EK Instructions Manual

10

three-step quick start

Three-Step Quick Start
For Step
Auto Setup or Preset Download.
before you start
Check that the VCR is
turned off and no
cassette is inserted
Load the battery into the
Remote Control
Refer to the Remote
Control diagram
on pages 6–7
Unless indicated
otherwise, use the
buttons on the Remote
Control
Check that the
connection is completed
Turn on the TV
i
ENTER
– –:– –
PR
3
PR
AUDIO – –:– –
3
VPS/PDC
0000
5
? 30 SEC
PR
3
PR
PR
i
2 4
ENTER
LP00000-000
VCR/TV
, be sure to perform either of the methods:
Auto Setup
START AUTO SETUP
Press the o button. If 'Auto' appears on the display panel, press
what will happen?
word 'Auto'. Do not press any button on the VCR or the Remote Control.
note If you have connected both the RF cable and the fully-wired 21-pin SCART
cable, and if your TV offers T-V Link, etc., and the TV is turned on, the VCR
automatically performs the Preset Download (
for Auto Setup function.
Auto Setup is running: don't
touch any buttons
AUTO SET
PLEASE WAIT
[MENU]: EXIT
SELECT THE VIDEO CHANNEL
When
Auto Setup
If you have only used the RF
rf cable only
Cable to connect the VCR to the TV, you will
see this display. The number is the channel on
the TV that the
Auto Setup
video channel. In the example, we have presumed that channel 52 is vacant and
have set the VCR to 52:
rf and scart connection
to connect the VCR to the TV with both the RF
Cable and a 21-pin SCART Cable (not provided),
you need to press PR
until the figure reads '– –'. This is because you will use the TV in AV mode to view
video pictures and therefore do not need a dedicated video channel.
The display panel on the front of the VCR will show the
The VCR is automatically setting up the tuner
SAT
channels, clock, the VIDEO Plus+ assigned Guide
VCR
Program numbers and the video channel. This only
REVIEW
happens the first time that the VCR is turned on.
rf and scart connection
connect the VCR to the TV with both the RF Cable
and a 21-pin SCART Cable (not provided) and the
TV set is in its AV mode (see the TV manual), you
will see the following information displayed on
your TV screen:
Your TV screen during Auto Setup if SCART is used
has finished, you will see the following display panel on your VCR:
has chosen to be the
Now tune the TV set to channel 52 (refer to TV manual if
necessary); you should see two vertical white bars appear
on the TV screen. If the bars do not appear or are not
clear, choose another vacant channel pressing PR +/
the Remote Control and try again. If you cannot obtain
the vertical white bars on any channel between 22 and 69,
consult your local JVC dealer.
If you have chosen
- - on the Remote Control
(or E).
pg. 11) even if you select 'Auto'
If you have chosen to
SAT
VCR
REVIEW
- - on
SAT
VCR
REVIEW