Advertisement
Quick Links
Installation Information
INSTALLATION INFORMATION
The Wolf warming drawer is designed to be set into a built-in wall or cabinet installation.
This section of the manual covers some of the installation issues that a service technician may need to know when
servicing a Wolf warming drawer. If additional installation information is needed after reviewing this section of the
manual, please refer to the installation guide or contact the Wolf Appliance Customer Service Department.
Electrical Requirements
• 110 to 120 Volts AC, 60Hz, 15 ampere fused electrical supply
• Separate electrical circuit serving only this appliance
• A properly grounded 3-prong receptacle
•
TO AVOID SHOCK HAZARD, THE INSTALLATION SITE MUST BE EQUIPPED WITH A PROPERLY
GROUNDED 3-SLOT RECEPTACLE TO MATCH THE 3-PRONG (GROUNDED) POWER SUPPLY CORD
PROVIDED ON THE APPLIANCE.
•
TO AVOID SHOCK HAZARD, NEVER REMOVE THE GROUND PRONG FROM THE PLUG OF THE POWER
SUPPLY CORD.
#802981 Rev. A Jan. 2005
Neutral
Ground Prong
Figure 2-1. Electrical Receptacle & Power Cord
WARMING DRAWER
Line
Voltage
(Power)
Ground
2-2
Advertisement
Related Manuals for Wolf 13005870
Summary of Contents for Wolf 13005870
- Page 1 This section of the manual covers some of the installation issues that a service technician may need to know when servicing a Wolf warming drawer. If additional installation information is needed after reviewing this section of the manual, please refer to the installation guide or contact the Wolf Appliance Customer Service Department.
- Page 2 WARMING DRAWER Installation Specifications (Non-Integrated) The warming drawer is designed to be set into a built-in installation alone, or in combination with a Wolf wall oven, microwave oven or cooktop. The illustration below shows the rough-in dimensions for a “non-Integrated” warming drawer installation below a wall oven (See Figure 2-2).
- Page 3 The illustration below shows the rough-in dimensions for an “Integrated” warming drawer installation below a wall oven (See Figure 2-3). NOTE: Prior to serial #13005870, the warming drawer could not be installed in an Integrated application. For complete installation instructions, refer to the installation guide. NOTE: Minimum required cabinet width = 33" (838 mm) Minimum required cabinet depth = 26"...