Table of Contents
Advertisement
TROUBLESHOOTING GUIDE (continued)
LED PANEL
CODE
LED Panel Code Flash & Alarm On (NOTE: Always turn off the power before cleaning and servicing).
1. Circulation line is blocked.
2. Incorrect inlet and outlet hose
3. Scale on the flow sensor.
4. Flow sensor cord is loose.
5. Flow sensor failure.
1. Dirt or scale on titanium plates.
2. Low salt level / No salt.
3. Electrolytic cell cord is loose.
4. Possible electrolytic cell failure.
1. High salt level.
1. Display and all lights are off - the
SAVE THESE INSTRUCTIONS
PROBLEM
direction.
system does not power up.
SOLUTION
• If your unit has plunger valves, ensure
that they are open.
- Clear your basket and cell of debris and dirt. See "Maintenance"
- Depress the 6-way valve, release all
trapped air in the circulation line.
• Check the direction of the inlet and the
outlet hose. Reverse the hoses if
necessary. See "Set Up Instructions".
• Clean the flow sensor, paying special
attention to the hinge. See
"Maintenance".
• Plug the flow sensor firmly into the flow
sensor receptacle.
• Contact Intex Service Center.
• Remove the electrolytic cell for
inspection. Clean it if necessary.
See "Maintenance".
• Add salt. See "Salt & Pool Water
Volumes".
• Ensure that the cell cord is plugged
firmly into the cell housing receptacle.
• Contact Intex Service Center. Replace
the cell if needed.
• Partially drain the pool and refill it with
fresh water. See "Salt & Pool Water
Volumes".
•
Household voltage is too high or too low
(+ 20%). Check the voltage is within the
Range stated on the device housing.
- Contact Intex Service Centre
Hide quick links:
Advertisement
Table of Contents
