Motorola MTM800 Installation Manual page 56

56
To install the cable, carry out the following steps.
1. Connect the stripped lead of the fuse holder cable only to an ignition switched terminal of the
fuse block. Use the supplied terminal or any other suitable terminal.
2. Mount the fuse holder using the mounting hole, and dress wires as required.
3. Cut the thin cable to the required length, crimp the supplied red lead to the stripped lead of the
thin cable, and connect it to the blue terminal of the fuse holder cable.
4. Connect the other end of the ignition sense thin cable to pin 4 of the junction box terminal.
5. Insert the provided fuse into the fuse holder and close the cover.
Connection Plan for External PTT
MTM800 Enhanced Mobile Terminal Installation Manual
PIN 4: If the ignition line is not used, it needs to be
grounded. Interference can cause radio to hang.
1
2
3
4
5
6
JUNCTION BOX TERMINAL
7
version a)
3
3
version b)
7
INSTALLATION