Table of Contents
Advertisement
In Canada and some other regions, local codes require the unit be connected only to a circuit
that is protected by a ground-fault circuit-interrupter (GFCI). The installer should provide this
GFCI requirement. The GFCI should be tested on a regular basis by pushing the test button. If
the GFCI fails to operate correctly, there is ground current flowing indicating the possibility of
an electric shock. Do not use this unit. Disconnect unit and have a qualified professional correct
the problem before using.
A Build-up of flammable fumes can result in a hazardous condition if the Cell is allowed to
operate without flow. This machine must be operated only with an approved in-line flow sensor.
The flow Sensor must be installed between the last piece of apparatus and the Cell, upstream of
the Cell.
ALWAYS ADD ACID TO WATER, NEVER WATER TO ACID
Section 3. Installation Instructions
Section 3.1 General Information:
Box, cell and Flow Sensor. They are manufactured from the latest corrosion resistant
materials to give you years of trouble free use, and installing them in the most sheltered
position from sun and water will protect them from extreme weather conditions for years
to come.
Safety Measures
1. Only operate the system with an approved flow sensor.
2. See safety measures and warnings on page 2 of this manual.
Additional Materials Required
1. PVC solvent cement and priming fluid
2. Hacksaw or pipe cutters
3. Screwdrivers
4. Drill
5. Teflon Tape (a.k.a. Plumber's Tape)
6. Silicone Sealant (DO NOT USE silicone glue or petroleum jelly).
7. Pipe adaptors (i.e. reducer couplings) if needed for systems with 1 ½ inch plumbing.
CAUTION
WARNING
CAUTION
DANGER
SAVE THESE INSTRUCTIONS
The system comes in three sections, the Control
Page 2
Advertisement
Table of Contents
