Connecting An Antenna Or Cable Tv; Connctions To Your Tv - Insignia IS-DVD100121 Installation And Operating Manual

Connecting an Antenna
Connecting an Antenna
or Cable TV
or Cable TV
a a Antenna
:
Disconnect the antenna from the rear of the TV and
identify the antenna cable. If it is a round 75 ohm
coaxial cable connect it directly to the jack marked
ANT.IN on your Recorder. If your antenna cable is flat
connect it to a 300-ohm to 75-ohm antenna adaptor
(not supplied) and slip the adaptor over the ANT.IN
jack. Don't attempt to screw it into to the Recorder.
b Cable TV: b
If your cable connection has no converter or
descrambler, unscrew the cable from your TV and
attach it to the ANT.IN jack on the Recorder. If a con-
verter is required connect a coaxial cable from the
wall jack to the IN connector on the converter, and a
coaxial cable from the OUT connector on the convert-
er to the ANT.IN on your Recorder. This cable hookup
permits both TV and Recorder operation.
a
Antenna
OR
Rear of Recorder
b
To view or record a CATV channel
1. Tune the TV to the Recorder output channel (CH
2. Set the Recorder channel selector to the cable
3. Select a channel using the cable converter.
Notes:
•
•
Connections to your TV
Connections to your TV
Make one of the following connections, depending on
the capabilities of your TV.
Antenna
OR
3 or 4).
output channel. (Example: CH3)
With this connection, you cannot record one program
while viewing another.
If you are using a cable box to tune channels, it is not
necessary to do Auto Channel Set.
15