Problem: Image is too wide or narrow for screen
You might need to manually adjust the tracking to reduce or
•
enlarge the projected image. Refer to "Manual Tracking" on
page 30.
Adjust the resolution of your monitor if it's greater than
•
1280x1024. Only this resolution at 75 Hz or less will display on
the projector.
Problem: Image is out of focus
Turn the projection lens to focus the image.
•
Make sure the projection screen is at least 4 feet (1.2m) from the
•
projector.
Make sure the projector is turned off, then check the projection
•
lens to see if it needs cleaning.
Problem: Image and menus are reversed left to right
Rear projection mode is probably turned on. Switch back to for-
•
ward projection from the Controls menu. The image should
immediately return to forward projection. See "Rear Projec-
tion" on page 32.
Problem: Image and menus are upside down
Ceiling mode is probably turned on. Turn off the mode from
•
the Controls menu. The image should immediately return to
forward projection. See "Ceiling Projection" on page 32.
Problem: the projector displays vertical lines, "bleeding" or spots
Adjust the brightness. See "Brightness + or -" on page 22.
•
Make sure the projector is turned off, then check the projection
•
lens to see if it needs cleaning.
Problem: no sound
Press the mute button.
•
Adjust volume.
•
Verify audio/input connections.
•
Adjust audio source.
•
45