Connecting An External Speaker - InFocus LP1000 Reference Manual

4 Plug the A/V cable's white connector into the left "audio out"
port on your video player. Plug the cable's red connector into
the right "audio out" port on the video player.
If you're using an S-video or BNC cable, the yellow connec-
•
tors on the A/V cable remain unused (Figure 12).
5 Plug the A/V cable's other white and red connectors to the
left and right "audio in" ports on the projector directly above
your video connection.
The projector is compatible with the these major broadcast video
standards: NTSC, NTSC 4.43, PAL, PAL-M, PAL-N and SECAM.
It automatically adjusts to optimize its performance for the
incoming video. The input signals for SECAM, PAL-M, and
PAL-N video cannot be automatically detected, therefore they
must be chosen manually; see "Video Standard" on page 33.

Connecting an External Speaker

To connect one or two external speakers, plug the speaker cable
into the (audio out) connectors on the projector. The external
speaker's volume is controlled by the projector; see "Volume" on
page 25.
F
IGURE
Connecting external speakers
CAUTION: Your video player
may also have a "Video Out" port
for a coaxial cable connection.
DO NOT use this to connect to the
projector.
13
15