Advertisement
EXTERIOR CONTROL SWITCH -
Step
1
Locate the exterior control switch and the jack plug harness included with the kit (Figure 30).
Figure 30: External Winch Control Kit
Step
2
Install the jack plug at the desired location on the UTV. Mounting holes may need to be cut/drilled in order to
fasten the jack to plastic body parts (Figure 31).
Figure 31: Example Mounting Location
Step
3
Route the jack harness to the winch control module and connect the black and green wires to their corresponding
locations, shown in
Figure 24: Switch to Controller
the dash.
(E)
Connect the red wire to the open connector on the winch wiring harness.
OPTIONAL
Wiring. Connect the red wire to the 12V accessory charger in
Win ch I n s ta l la ti o n
|
PAGE 10
Advertisement
