Fisher & Paykel DISHDRAWER DD24SCTB9 Troubleshooting

Hide thumbs Also See for DISHDRAWER DD24SCTB9:

Download this manual

Troubleshooting

Excessive water remaining above the filter plate, after the rinse cycle. (This is displayed as

fault)

• Check for a kinked drain hose, blocked waste connection, highloop not properly installed, drain hose not routed

correctly or spray arms not in place.

No water supply. (This is displayed as an

fault )

• Check water is connected and turned on.

The dishwasher is beeping continuously

• There is a fault. See section 'If there is a fault' in the User guide for further information and instructions.

No program indicator lights up when the drawer is opened

• Ensure power is connected and is switched on. If it is and still no indicator lights up, see the 'Preference options'

section of the 'Quick start guide'. An option called 'Open drawer auto power-on' may need to be turned on.

Water around water supply and drainage connections

• Check connections, existing plumbing and hoses for leaks. Check rubber washer and hose clamp are correctly

fitted.

If product is tipping

• Ensure the product is secured to the cabinetry.

https://producthelp.fisherpaykel.com/us/Clean/DishDrawer%E2%84%A2/Single/DD24SCTB9/Installation_Guide_DD24SCTB9...

Updated: Tue, 16 Nov 2021 11:47:00 GMT

Page 1 Troubleshooting Excessive water remaining above the filter plate, after the rinse cycle. (This is displayed as fault) • Check for a kinked drain hose, blocked waste connection, highloop not properly installed, drain hose not routed correctly or spray arms not in place. No water supply.
Page 2 If front panels are Misaligned • Check and re-level product. Check the cabinetry is square. For Integrated models, check and adjust front panel alignment if necessary. Drawer doesn’t close properly • Ensure nothing is obstructing the drawer from closing properly eg hoses or drawer latches. •...