Setup Menu Function (Firmware After Ver 2.20En) - Citizen CMP-10 User Manual

4.10 Setup menu function (Firmware after Ver 2.20EN)

Make sure the printer power is off. Press ON/OFF switch and keep
pressed for about 5 seconds until .LED is changed to red and leave the
switch. Then buzzer beeps and printer prints current setting and goes
to setup menu as follows.
Example
DISCOVERABILITY:
PAIRING INFO SAVING:
MEMORY SWITCHES:
BAUD RATE:
POWER OFF TIME:
PRINT DENSITY:
MAX IrDA SPEED 57600: NO
<ON/OFF> - NO, <LF> - YES
CHANGE DISCOVERABILITY ?
The setting can be done by choosing NO (ON/OFF switch) or YES
(LF switch) against coming up questions .
During the menu setting, if YES is chosen somewhere, following
question comes up at the end of setup menu
SAVE SETTINGS ?
If you want to save the changed setting, choose YES here and if not,
choose NO.
If YES is not chosen, the new setting will not be effective.
Setup menu ends with Power off in any case.
SETUP MENU
YES
YES
00000000
9600
10 min
100%
— 29 —