Icom IC-R8500 Instruction Manual page 6

1
PANEL DESCRIPTION
@1
MEMORY SET SWITCH [M-SET] (p. 19)
Used to 'copy and paste' the displayed frequency
into another memory channel.
• The first push is used to copy (
ond push is used to paste (
• Frequency, mode, tuning step, memory name, etc. can
be programmed into a temporary memory.
@2
MEMORY CLEAR SWITCH [M-CL] (p. 19)
Push and hold to clear the contents of the displayed
memory.
• Bank names cannot be cleared.
@3
MEMORY WRITE SWITCH [MW] (p. 19)
Push and hold to store the displayed frequency,
mode, tuning step, etc. into the selected memory
channel.
@4
BANK SWITCH [BANK] (p.17)
Push momentarily to toggle the bank limit func-
tion ON and OFF (p 18).
• While "BANK" appears, only memory channels within
the selected bank can be selected via the [M-CH] se-
lector.
Push for 1 sec. to increase/decrease the number of
memory channels in the selected bank (p. 21).
@5
MEMORY CHANNEL SELECTOR [M-CH] (p.18)
Selects a memory channel in normal use.
• Clockwise rotation selects higher memory channel
numbers; counterclockwise rotation selects lower
memory channel numbers.
Selects a set mode item when quick set mode or
initial set mode is selected (p. 30).
@6
DELAY/SPEED CONTROL [DELAY/SPEED] (p.28)
Adjusts the scan delay time or scan speed depend-
3
appears), and the sec-
M
disappears).
M
POWER
SLEEP/
SET
REC
REMOTE
WFM
REC OUT
NB/AFC
AF GAIN
PHONES
ing on the [DLY ] switch setting.
D/S
• When scan delay time is assigned, this control adjusts
the scan delay time (scan pausing interval) during signal
reception. This setting is effective when "
selected for the scan resume condition.
• When scan speed is assigned, this control adjusts the
scan speed. In this case, scan delay time is determined
while setting.
@7
SCAN SWITCHES [SCAN
All of these switches are related to the scan function
in some way as follows:
[MEMO] (p. 23)
Push momentarily to start/stop memory scan.
Push numeral keys, then this key to start memo-
ry scan in the specified bank.
Push this key, then a mode switch to activate
mode select scan function.
Push for 1 sec. to set automatic bank and skip
functions.
• The bank limit function and/or memory skip functions
are activated automatically when "AUTO" is selected
and scan is started.
[SEL] (p. 23)
Push momentarily to start/stop memory select
scan.
Push for 1 sec. to set the memory channel as a
select channel.
[PROG] (p. 24)
Push momentarily to start/stop programmed scan.
Push numeral keys, before or after pushing this
key to start programmed scan using the specified
scan edge group.
• 10 scan edge groups are available.
Push for 1 sec. to program scan edges for pro-
FM
S 1 3 5 7 9 + 20dB + 60dB
SLEEP
LOCK
SIGNAL
NB AFC AGC-F
iC- r8500
RECV
COMMUNICATION RECEIVER
MODE
FM AM SSB/CW
AGC 10dB 20dB
SQUELCH APC IF SHIFT
" is
]
SCAN SET
BANK
APF-N
ICOM
10-ATT-20
TS
TS
SPCH
LOCK
APF