Memory Names - Icom IC-A23 Instruction Manual

4
MEMORY OPERATION

Memory names

ï Programming memory names
The memory channel can display a 6-character comment as
well as a frequency.
q Rotate the [DIAL] to select the desired frequency in Fre-
quency mode.
w Push
, then push [MR].
e Rotate the [DIAL] to select the desired memory channel to
be programmed.
• Push [BANK] to select the BANK number if desired. Push [CLR]
to exit the BANK selection mode.
r Push [MR] to enter the memory name programming mode.
• "-- -- -- -- -- -- " appears on the display.
t Push the appropriate digit key several times to select the
desired character as listed at right.
• To erase a character, overwrite with a space (displayed as _).
• To move the cursor forwards or backwards, use [DIAL].
y Push [ENT] to program the name.
• Flashing stops.
• When no name is programmed, the display shows the operating
frequency.
• To clear the entered comment, push [CLR] before pushing [ENT].
14
key Character key Character
1 1, Q, Z 2 2, A, B, C
4 4, G, H, I 5 5, J, K, L
7 7, P, R, S 8 8, T, U, V
ENT Program 0 0, space –
ï Clearing memory contents
Unwanted memory channels can be cleared. Programming
over a memory channel also clears the previously pro-
grammed contents. Memory channel 1 cannot be cleared.
q Select the memory channel to be cleared.
w Push
, then push and hold [CLR] for 1 sec.
• "-- -- -- -- -- --" appears momentarily, then the next selec-
table channel appears.
key Character
3 3, D, E, F
6 6, M, N, O
9 9, W, X, Y