Selecting The Conduits For A Modem Hotsync Operation - IBM WorkPad Workpad Handbook

Note:
If you plan to connect to your company's dial-in server
(network modem) instead of connecting to a computer
modem, see "Conducting a HotSync operation
via a network" later in this chapter.
6. Enter the telephone number to access the modem connected to
your computer.
7. If needed, enter a dial prefix (such as "9") to access an outside line,
and then tap the Dial Prefix check box.
Tip: You can enter a comma in the field to introduce a "pause"
in the dialing sequence. Each comma equals a two second
pause.
8. If the phone line you're using for the PC companion has Call
Waiting, select the Disable call waiting check box to avoid an
interruption during the modem HotSync operation.
9. If you want to use a calling card to place the call, select the check
box and enter the calling card number.
10. Tap OK.
Selecting the conduits for a modem
HotSync operation
The Conduit Setup dialog box on your PC companion enables you to
define which files and/or applications synchronize during a modem
HotSync operation. You can use these settings to minimize the time
required to synchronize data with a modem.
To change the Conduit Setup for a modem HotSync operation:
1. Tap the Applications icon
2. Tap the HotSync icon
3. Tap the Menu icon
4. Tap Options, and then tap Conduit Setup.
5. Tap the check boxes to deselect the files and applications that you
do not want to synchronize during a modem HotSync operation.
The default setting is to synchronize all files.
Page 176
.
.
.
Advanced HotSync® Operations