Performing An Ir Hotsync Operation - IBM WorkPad Workpad Handbook

Note:
See the documentation for your operating system for
instructions on finding the simulated port. This
information is usually located in the Control Panel.
6. Click OK.
Note:
If your cradle is connected to a USB port, you can
continue using it while HotSync Manager is configured
for infrared communication. If your cradle is connected to
a serial port, you cannot use your HotSync cradle again
until you reconfigure the HotSync Manager to
communicate with the port defined for cradle
synchronization.

Performing an IR HotSync operation

After you complete the steps to prepare for performing an IR HotSync
operation, it is easy to perform the actual operation.
To perform an IR HotSync operation:
1. In the Applications Launcher, tap the HotSync icon.
2. Tap Local.
3. Tap the pick list below the HotSync icon and select IR to a
PC/Handheld.
4. Position the IR port of your PC companion within a couple of
inches of the infrared port of your computer.
5. Tap the HotSync icon to start the IR HotSync operation.
Chapter 7 Page 171