Table of Contents
Advertisement
l.
AT+CGPADDR: This command returns a list of PDP addresses.
m. AT+QNWINFO: This command queries the network information such as access
technology, operator's numeric code, the band and channel ID.
n. AT&W0: Use this command to
profile in non-volatile memory
For GNSS to work with QNavigator, make sure the following is issued:
AT+QGPSCFG="outport","usbnmea": Use this command to
o.
settings, including NMEA sentences output to the BG96 USB port.
The BG96 is connected to two GPIOs (GPIO26 and GPIO64) which produces a maximum of 1.8V. You can set
them using the following commands:
AT+QCFG="gpio",1,26,1,0,7
AT+QCFG="gpio",3,26,1
AT+QCFG="gpio",1,64,1,0,7
AT+QCFG="gpio",3,64,1
The following are screen shots of some of these AT commands:
Board Rev 2.2
stores the current AT command settings to a user defined
//configure pin 26 as output, no pull, 17mA drive, clean last configuration
// write pin 26 high value, clean last configuration
//configure pin 64 as output, no pull, 17mA drive, clean last configuration
// write pin 64 high value, clean last configuration
Copyright © 5GHUB.US
configure various GNSS
30
Advertisement
Table of Contents
