Controls And Starting A Wash - Fisher & Paykel DW60 User Manual

To start a wash programme
1 Press
to turn the dishwasher on.
2 Check that the wash programme displayed is the one you would like to use. If not, press
to scroll through the wash programmes (see section 'Changing the wash programme'
below).
3 Once the display shows the programme you would like to use, press
display will show the approximate time remaining and the stage of the wash.
Note:
the default cycle when you first turn the dishwasher on is Normal
●
the dishwasher will remember the last programme used.
●
To pause and restart a wash programme
1 Press
to pause the programme. The programme status (eg Wash) will flash while the
dishwasher is paused.
2 Open the door very slowly.
IMPORTANT!
There is a risk of being sprayed with hot water. Do not fully open the door until the
spray arms have stopped rotating.
3 Load, remove, or rearrange any dishes if needed.
4 Press to restart the programme.
If the dishwasher is not restarted within 7 minutes, it will then beep until the cycle is
restarted.
Changing the wash programme
Note: The dishwasher will remember the last programme used.
1 Press to turn the dishwasher on.
2 Press Program to scroll to the desired wash programme.
The display will show the wash programme time.
●
3 Select a wash modifier (optional, DW60C6 models only)
Press to scroll between the wash modifier options. The selected wash modifier
●
indicator will be lit. (see 'Selecting wash modifiers').
4 Press to start the wash programme.
At the end of the programme the dishwasher will beep. The display will show
After 30 seconds the display will turn off.
4

CONTROLS AND STARTING A WASH

to start. The
0
.