Moving The Range - Fisher & Paykel OR36SCI6 Installation Manual

Fitting the adjustable (rear) feet covers (optional)
If installing rear feet covers use the following instructions to attach the mounting brackets to the base of the range.
A
B C
1 Remove screws A, B and C from the
plate on the base of the range.
IMPORTANT!
When raising the range to upright position always ensure
z z
two people carry out this manoeuvre to prevent damage
to the adjustable feet.
BE CAREFUL: do not lift the range by the oven door
z z
handle, the hob rail or the cooktop trim as this may
damage the appliance.
When moving range to its final position DO NOT DRAG.
z z
Lift feet clear of floor.
12
FITTING THE ADJUSTABLE FEET
C
2 Replace screw C with one of the
screws supplied with the feet covers.
This screw must be replaced before
z z
attaching the mounting bracket to the
base of the range.

MOVING THE RANGE

Washers
3 Attach the mounting bracket to
the base of the range using the
supplied screws.
Ensure the two supplied washers are
z z
fitted between the rear edge of the
bracket and the base of the range
(as shown).
4 Secure covers to brackets using the
provided screws.