Yamaha AG200F Owner's Manual page 45

4 3 2
1. Drain plug
2. O-ring
3. Compression spring
4. Oil strainer
3. Remove the drain plug and
drain bolt.
cC
When removing the oil drain plug,
the O-ring, compression spring,
and oil strainer will fall out. Take
care not to lose these parts.
PERIODIC MAINTENANCE AND MINOR REPAIR
1
1. Filter cover screw (×2)
2. Drain bolt
NOTE:
The oil filter cover is secured by
two screws and a drain bolt.
Remove the drain bolt to drain the
EC000070
filter cavity.
4. Remove the filter cover screws
and the oil filter cover.
5. Remove the oil filter element
and O-ring.
6. Clean the oil filter and strainer
7. Check the O-rings. If damaged,
1
8. Install the drain plug, filter
2
NOTE:
Make sure the O-ring is seated
properly.
cC
Before reinstalling the oil drain
plug, do not forget to install the O-
ring, compression spring, and oil
strainer in position.
6-9
with solvent. Replace if neces-
sary.
replace.
cover, screws and drain bolt.
Tighten the drain plug to the
specified tightening torque.
1
2
3
4
5
6
EC000071
7
8
9