Yamaha F4 Owner's Manual page 35

EMU30861
Manual start models (tiller control)
1. Place the gear shift lever in neutral.
NOTE:
The start-in-gear protection device prevents
the engine from starting except when in neu-
tral.
2. Attach the engine shut-off cord to a se-
cure place on your clothing, or your arm
or leg. Then install the clip on the other
end of the cord into the engine shut-off
switch.
EWM00121
WARNING
Attach the engine shut-off cord to a se-
G
cure place on your clothing, or your
arm or leg while operating.
Do not attach the cord to clothing that
G
could tear loose. Do not route the cord
where it could become entangled, pre-
venting it from functioning.
Avoid accidentally pulling the cord dur-
G
ing normal operation. Loss of engine
power means the loss of most steering
control. Also, without engine power,
the boat could slow rapidly. This could
cause people and objects in the boat to
be thrown forward.
N
ZMU02682
3. Place the throttle grip in the "
(start) position.
4. Pull out / turn the choke knob fully. After
the engine starts, replace / return the
knob to the home position.
NOTE:
It is not necessary to use the choke when
G
starting a warm engine.
If the choke knob is left in the "
G
(start) position while the engine is running,
Operation
ZMU02683
"
ZMU02684
ZMU02669
"
30