Replacing Door Hinge Spring; Replacing Magnetic Gasket - Hussmann Innovator Installation And Service Manual

Innovator Door Installation and
Service Instruction
6. Rock the door out and pull the bottom hinge
pin out from the bottom socket.
7. Install the new door in reverse order.
8. Adjust the torque on the new door. If needed,
adjust sag.

REPLACING DOOR HINGE SPRING

The door must be removed before replacing the
door hinge spring.
Pull the hinge spring assembly out of the bottom
of the door and replace with a new assembly. See
Figure 8. Note that there are right-hand and left-
hand hinge spring assemblies.
Figure 8. Replacing Door Hinge
Spring Assembly
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A. • WWW.HUSSMANN.COM

REPLACING MAGNETIC GASKET

Carefully remove the old gasket from the groove
in the back of the door, Figure 9.
Figure 9. Removing Door Gasket
The new gasket will be easier to work with if it is
at ambient temperature. Begin by lubricating the
new gasket with a mild soap and water solution.
P/N 0425683F
Gasket
5