Door Seal; Fan Cycle Switch; Lamps; Sealing Case To Floor - Hussmann ARL Installation And Operation Manual

Door seal (closing mechanisms).
-Hinged Doors. Check to ensure the door torque is capable of closing the door automatically. Open the door
45 degrees and release it, the door should close and seal.
To adjust the torque, place a wrench on each of the 2 nuts located on the bottom hinge. Hold the top wrench
firmly and loosen the bottom nut. Torque is increased or decreased by rotating the top nut. After adjustment
has been made, tighten the bottom nut.
-Sliding Doors. Check to ensure the doors slide properly. Open each door independently half way and
release it, the door should close and seal.
Check the bottom rollers, they must be centered on the stainless steel track.
Fan Cycle Switch (Hinged doors)
The evaporator fan is cycled off upon a door opening by a switch located above each door. This reduces the
amount of warm moist air introduced to the evaporator coil during door openings.
With the door open, depress the switch to ensure the evaporator fan is working.

Lamps.

Turn the lighting switch on to ensure the lamps are operating correctly. Check to ensure the lamps are in
their place and the terminals remain in contact with the lamps supports.
All interior lamps are equipped with a plastic shield, be sure the shield is installed properly.

Sealing Case to Floor

IF REQUIRED by local sanitary codes or if customer so desires, cabinets may be sealed to the floor using a
vinyl Cove Base Trim such as produced by Armstrong, Kentile, Johnson, etc. and available at any floor
covering supplier. The size required will depend on the amount of variation there is in the floor from one
end of the case to the other.
When installing the cove base trim to the base:
1) Remove all dirt, wax and grease from the surface area of the cabinet and floor where adhesion is
necessary to ensure a good, secure installation.
2) Apply a good contact cement to the cove base trim and allow proper drying time according to the
directions supplied with cement.
3) Install the cove base trim so that it is lying flush to the store floor.
4) Caulk remaining cracks and joints as required.
Case
Cove Trim
Cement