Cisco SFS InfiniBand Server Switch SFS 7000P Hardware Installation Manual page 37

Chapter 3 Installing the Switches
Check the rack for clearance for the switch. The switch can be installed either directly on top of another
Step 4
device or be suspended from the rack posts.
Attach the remaining two rack brackets to your rack.
Step 5
Position a bracket toward the back of the rack with the flange facing away from the rack. The flange
a.
should go around the outside of the rack post, as shown in
Figure 3-3
Note
Secure the bracket with the screws through the back of the rack, as shown in
b.
c. Repeat on the other side of the rack.
Figure 3-4
Step 6 Lift the switch unit, and align the sliding brackets to the switch with the brackets attached to the posts
before sliding them together.
OL-10853-01
Holding Bracket Inside of Rack
If you are rack-mounting the switch backward, the bracket should be installed to the front of the
rack.
Secure Rail Bracket to Rack with Screws
Cisco SFS 7000P and SFS 7000D InfiniBand Server Switches Hardware Installation Guide
Rack-Mounting the Switches
Figure 3-3.
Figure 3-4.
3-5