Catalyst 4510R-E Switch
Table 1-7
Catalyst 4510R-E Switch Features
Feature
Chassis
Supervisor engines
Modules
Backplane
Port density
Inline power
Catalyst 4500 E-Series Switches Installation Guide
1-16
Description
Ten horizontal slots. Slots are numbered from 1 (top) to 10 (bottom).
•
Supports the following supervisor engines:
Supervisor Engine 7-E
–
Supervisor Engine 6L-E
–
Supervisor Engine 6-E
–
Supervisor Engine V-10GE
–
Supervisor Engine V
–
Refer to your software release notes for the minimum software
Note
release versions required to support the supervisor engines.
Supervisor engines must be installed in slot 3 or in slot 4.
•
•
Supervisor engine redundancy is supported in this chassis.
The Catalyst 4510R-E switch supports 1+1 supervisor-engine
Note
redundancy for integrated resiliency. With the support of stateful
switchover (SSO), the secondary supervisor engine serves as a
backup to immediately take over after a primary supervisor failure.
During the switchover, Layer 2 links are maintained transparently
without the need to renegotiate sessions.
Supports up to nine Catalyst 4500 series modules.
•
Some Catalyst 4500 series modules may:
•
Not be supported
–
Require that you install a specific supervisor engine
–
Have chassis slot restrictions
–
Require a specific software release level to operate
–
Check your software release notes for specific information.
•
24 Gbps full duplex per slot on five slots, plus 12 Gbps full duplex per slot
on three slots (276 Gbps) with Supervisor Engine 6-E
•
10/100 (RJ-45)—384 ports
•
10/100 with PoE (RJ-45)—384 ports
10/100 with or without PoE (RJ-21)—384 ports
•
100FX (MT-RJ)—384 ports
•
100LX-10 (MT-RJ) or 100BX-D (LC)—384 ports
•
1000BASE-X—388 ports
•
10/100/1000BASE-T—384 ports
•
10/100/1000BASE-T with PoE—384 ports
•
10GBASE-X—34 ports
•
Integrated support, 820 W per switching module
Chapter 1
Product Overview
OL-13972-02