Ⅲ. Installation Of Wire Spool - Yeswelder MIG PRO-200 User Manual

1) Using CO2/MIG,MAG functions, please plug joint into red socket and earth clamp into black socket, plug
the welding torch into the on the front panel and screw it tight. Meanwhile, insert the welding wire into the
welding torch by hand from built in wire feeder.
2)
Using Gasless function,connect, please plug joint into black socket and earth clamp into red socket,plug the
welding torch into the on the front panel and screw it tight. Meanwhile, insert the welding wire into the welding
torch by hand from built in wire feeder.
3) Using MMA and TIG LIFT functions,plug electrode holder into red socket and earth clamp into black
socket.
Ⅲ. Installation of Wire Spool
1). Mount the wire spool with welding wire to the shaft of wire feeder. Lock the wire spool with the spool
holder.
2). Choose a suitable contact tip according to the size of welding wire.
3). Undo the screw of the of wire pressure-wheel and lead the wire into the groove of wire driving wheels via
the wire guide tube. Adjust the pressure wheel to ensure no slippage of wire occurs. But too much pressure
would cause deformation of welding wire and affect the wire feeding speed.
4). Release the welding wire roll by counter clock-wise direction. The head part of the welding wire is always
inserted into the fixing bore on the rim of wire spool to ensure avoid the looseness of wire. So please just cut
the bent head part off while using in order to avoid wire stuck.
5). Choose the correct track of the wire feeding groove by the welding wire diameter.
6). Press the "Inching" button to lead the wire out of the welding torch.