Cleaning the glass cooktop.
Glass surface—potential for permanent damage
Our testing shows that
if you are cooking high
sugar mixtures such as
jelly or fudge and have
a spillover, it can cause
permanent damage to the
glass surface unless the
spillover is immediately
removed .
30
(on some models)
Metal Marks and Scratches
Be careful not to slide pots and pans
across your cooktop . It will leave metal
markings on the cooktop surface .
These marks are removable using
the CERAMA BRYTE
®
Cleaner with the CERAMA BRYTE
Cleaning Pad for Ceramic Cooktops .
Cooktop Seal
To clean the cooktop seal around the edges
of the glass, lay a wet cloth on it
Damage from Sugary Spills and Melted Plastic
Turn off all surface units . Remove hot
pans .
Wearing an oven mitt:
a . Use a single-edge razor blade
scraper (CERAMA BRYTE
Cooktop Scraper) to move the spill
to a cool area on the cooktop .
b . Remove the spill with paper towels .
To Order Parts
To order CERAMA BRYTE
®
Cleaner and the cooktop scraper, please
call our toll-free number:
National Parts Center . . . . 800.626.2002
CERAMA BRYTE
Ceramic
®
Cooktop Cleaner . . . . . . . . . .# WX10X300
CERAMA BRYTE
Ceramic
®
Cooktop Scraper . . . . . . . . .# WX10X0302
Kit . . . . . . . . . . . . . . . . . . . . . . . .# WB64X5027
(Kit includes cream and cooktop scraper)
CERAMA BRYTE
Cleaning Pads for
®
Ceramic Cooktops . . . . . . .# WX10X350
Ceramic Cooktop
®
bottom of pans for roughness that would
scratch the cooktop.
for a few minutes, then wipe clean with
nonabrasive cleaners .
.
Ceramic
®
NOTE: If pitting or indentation in the glass
surface has already occurred, the cooktop
glass will have to be replaced. In this case,
service will be necessary.
Ceramic Cooktop
If pots with a thin overlay of aluminum
or copper are allowed to boil dry, the
overlay may leave black discoloration
on the cooktop . This should be removed
immediately before heating again or the
discoloration may be permanent .
WARNING:
Carefully check the
Any remaining spillover should be left
until the surface of the cooktop has
cooled .
Don't use the surface units again until
all of the residue has been completely
removed .