Fisher & Paykel WASHSMART WA1060E Installation Manual/User Manual page 12

Completing your installation
Turn on the water and check all hose connections for leaks. Make sure there are no kinks
● ●
in the hoses. Check the hose connections for leaks again after 24 hours.
Uncoil power cord, remove and discard the plastic pin cover, and plug into wall socket.
● ●
Connect the appliance to an earthed outlet protected by a fuse of suitable capacity.
● ●
IMPORTANT!
Do not touch or operate the washer with wet hands or with bare feet.
Installation test cycle
Your washer must be correctly installed before use. Check the installation and operation
of the washer using the following procedure:
Touch 'POWER'
1
Touch both the
2
Touch to start the installation test cycle. The display will show
3
The washer will beep to signal the end of the installation test cycle. If there are no faults
4
found, the washer will automatically turn off at the end of the installation test cycle.
Any faults will be displayed on the screen (refer to the back of this user guide to help
identify faults). If you need further assistance, please contact a Fisher & Paykel trained
and supported service technician or our Customer Care Centre. Refer to 'Customer Care'
section for contact details.
Note: WA7060M QuickSmart™ washer only – a manual check of the inlet hose
connections will be required as the installation test cycle will not verify if the hot and
cold inlet hoses are connected the correct way around.
ACCESSORIES AND SPARE PARTS
Available from your Fisher & Paykel dealer or a Fisher & Paykel trained and supported
service technician.
Blanking Cap
Hose Inlet Long (2 m)
Hose Inlet Large Bore
Drain Hose Extension
Power Cord
10
INSTALLATION INSTRUCTIONS
to activate your washer.
and 'Options' buttons at the same time, and hold for three seconds.
Part No. 388491P
Part No. 422680P
Part No. 426123P
Part No. 425627P
If the power cord of your clothes washer is damaged it is
highly recommended that it is replaced by a Fisher & Paykel
trained and supported service technician in order to avoid a
hazard, as it is not a standard power cord.
and the lid will lock.