Temperature Selection - Black & Decker BXSH37013GB Manual

ENGLISH (Original instructions)
Heat Setting Selection
♦
This heater offers a choice of Low and High heat
settings, along with an independent cooling/fan
mode.
♦
Press the Warm button on the unit's control
panel to cycle through the available heat settings.
The LED strip around the unit will light up in the
corresponding colour: blue for Fan mode, amber
for the Medium heat setting, and red for the High
heat setting.
♦
Press this button again when the High heat setting
is selected to revert back to cooling/fan mode and
start the cycle over from the beginning.

Temperature Selection

♦
This unit is equipped with an adjustable
o
thermostat, from 15 C to 35
♦
Repeatedly press the Temp Set on the unit's
control panel to manually adjust the temperature
level. The currently selected temperature level will
show on the unit's LED display as the thermostat
is adjusted.
NOTE: Temperature levels will increase or decrease
by increments of 1.
NOTE: The temperature selection function operates
in an ascending order only. To go back to a lower
temperature from a higher temperature, repeatedly
press the Temp Set button as many times as
required until the temperature selection cycle starts
over, then continue pressing it until the desired
temperature is selected. For example, to go from
o o
34 C to 17 C, press the Timer button twice until the
temperature cycles back around to 15, then press it
twice more until the LED display shows 17.
The Timer Function
♦
The unit is equipped with a 9-hour timer.
♦
Press the Timer button on the unit's control panel
to manually select timer lengths, from 0 to 9 hours.
The currently selected timer length will show on
the unit's LED display as the timer is adjusted.
♦
When a timer has been selected, the unit will
automatically carry out a heating cycle for the
chosen length of time, then turn itself off once it
elapses.
8
o
C degrees.
NOTE: The timer selection function operates in an
ascending order only. To go back to a timer length
from a longer timer length, repeatedly press the
Timer button as many times as required until the
timer selection cycle starts over, then continue
pressing it until the desired timer length is selected.
For example, to go from a 8 hour timer to a 2 hour
timer, press the Timer button twice until the timer
selection cycles back around to '0h', then press it
twice more until the LED display shows '2h'.
The Oscillation Function
♦
This unit is equipped with a horizontal oscillation
function, for more even air flow distribution.
♦
Press the Swing button the unit's control panel to
activate the oscillation function. The unit will begin
to swing from side to side to show this function
has been selected.
♦
Press the Oscillation button again while the unit is
oscillating to turn this function off. The fan will stop
swinging and remain locked at its latest angle.
Safety System
♦
The unit is also fitted with a tip over switch. Do not
use on thick and long pile carpets, as the heater
may not work, due the tip over switch not been
activated.
Cleaning and maintenance
WARNING: Before cleaning and maintenance,
switch the appliance off and remove the plug from
the socket, to prevent electric shock.
♦
Do not immerse any part of the appliance, power
cord or plug in water or other liquids.
♦
Use a soft damp cloth to wipe the surface. Avoid
using detergent, spray or chemicals as these may
cause damage to the appliance.
♦
Never use flammable or abrasive cleaning agents
to clean the appliance.
♦
Clean the air inlet and outlet regularly with a
vacuum cleaner.
♦
If the appliance is not used for an extended period
it must be protected against excessive dust and
dirt. Store the heater in a dry place away from
sunlight and dirt.