Cisco Catalyst 3550 Hardware Installation Manual page 26

Cisco systems multilayer switch user manual
Hide thumbs Also See for Catalyst 3550:
Table of Contents

Advertisement

Front-Panel Description
Table 1-4
Mode LED
SPEED
LINE PWR
1. Not available on Catalyst 3550-24PWR switches
2. Available only on Catalyst 3550-24PWR switches
Table 1-5
Port Mode
STATUS
(port status)
1
UTIL
(utilization)
DUPLX
(duplex)
SPEED
LINE PWR
1. Not available on Catalyst 3550-24PWR switches
2. Available only on Catalyst 3550-24PWR switches
Catalyst 3550 Switch Hardware Installation Guide
1-8
Port Mode LEDs (continued)
Port Mode
Port speed
2
Port inline power
Meaning of LED Colors in Different Modes
LED Color
Meaning
Off
No link, or port was administratively shut down.
Solid green
Link present.
Blinking green Activity. Port is sending or receiving data.
Alternating
Link fault. Error frames can affect connectivity, and errors such as
green-amber
excessive collisions, CRC errors, and alignment and jabber errors
are monitored for a link-fault indication.
Solid amber
Port is blocked by Spanning Tree Protocol (STP) and is not
forwarding data.
Note
Blinking amber Port is blocked by STP and is sending or receiving packets.
Green
Port LEDs display backplane utilization on a logarithmic scale. (See
Figure 1-4
Amber
Peak total backplane utilization over the last 24 hours.
Off
Port is operating in half duplex.
Green
Port is operating in full duplex.
10/100 and 10/100/1000 ports
Off
Port is operating at 10 Mbps.
Green
Port is operating at 100 Mbps.
Blinking green Port is operating at 1000 Mbps.
GBIC ports
Off
Port is not operating.
Blinking green Port is operating at 1000 Mbps.
2
Off
Inline power is off.
Green
Inline power is on.
If the Cisco IP Phone is receiving power from an AC power source,
the port LED is off even if the IP phone is connected to the switch
port. The LED turns green only when the switch port is providing
power.
Description
The port operating speed: 10, 100, or 1000 Mbps.
The inline power status: on or off.
After a port is reconfigured, the port LED can remain amber
for up to 30 seconds as STP checks the switch for possible
loops.
through
Figure
1-8.)
Chapter 1
Product Overview
OL-6155-01

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents