Installing Your Freezer; Unpacking Your Freezer; Adjusting Your Freezer; Proper Air Circulation - Hamilton Beach HBFRF355 Owner's Manual

Unpacking Your Freezer

1. Remove all packaging material. This includes the foam base and all
adhesive tape holding the freezer accessories inside and
outside.
2. Inspect and remove any remains of packaging, tape or printed
materials before powering on the freezer.

Adjusting Your Freezer

Your freezer is designed for freestanding installation only.
It should not be recessed or built-in.
When moving the freezer, never tilt it more than a 45-degree angle.
This could damage the compressor and the sealed system.
If the freezer is tilted let it stand in an upright position for at least 24
hours prior to plugging. This is to allow the refrigerant to settle.

Proper Air Circulation

was designed for, you should install it in a locatian where there
is proper air circulation, plumbing and electrical connections.
The following are recommended clearances around the refrigerator:
Sides.................4"(102mm)
Top..................24"(600 mm)
Back..................4"(102mm)
6
4