Advertisement
3.4.2 Removing the rear panel
(See Fig.3)
• Prior to performing the following procedures, remove the am-
plifier assembly.
(1) Remove the four screws C, twelve screws D and screw E
attaching the rear panel.
(2) Take out the rear panel from the amplifier assembly.
3.4.3 Removing the SP terminal board
(See Figs.4 and 5)
• Prior to performing the following procedures, remove the am-
plifier assembly and rear panel.
(1) From the top side of the amplifier assembly, disconnect the
card wires from the connectors
mother board. (See Figs.4 and 5)
(2) Disconnect the connectors CN401,
the SP terminal board from the connectors CN501,
and
CN504
on the mother board while lifting the SP termi-
nal board upward. (See Fig.5)
(3) Take out the SP terminal board from the amplifier assem-
bly.
Reference:
When attaching the SP terminal board, insert the SP terminal
board in the section a of the barrier.
CN101
and
CN102
on the
CN403
and
CN404
on
CN503
D
E
C
D
C
D
C
Fig.3
Mother
board
SP terminal
board
CN101
CN102
Tie band
Section a
Amplifier
assembly
Fig.4
CN401
CN403
CN404
CN101
CN102
Tie band
Fig.5
Rear panel
D
C
D
Amplifier
assembly
CN501
CN503
CN504
Mother
board
SP terminal
board
(No.MB108)1-19
Advertisement
