Adjusting The Progressivity Sensor; Final Operations - MASSEY FERGUSON 5400 Service Manual

Input unit - GBA20 with Power Shuttle
E . Adjusting the progressivity
sensor
28. Smear the sensor thread with Loctite 5922 or
equivalent.
Install and adjust the sensor.
29. Screw the sensor (1) home
it. Make sure that its end is in contact with the
drive pinion (2) (see section 5).
Unscrew the sensor 1/2 to 3/4 of a turn.
Tighten the nut to a torque of 5 - 7 Nm.
For operation, see section 11 - Electronics.
F . Final operations
30. Refit the spacer (4) (see section 3).
31. If removed, install the selector cover (see
section 5).
32. If removed, install the Power Shuttle clutch control
unit. Refit the lubricating pipes. Reconnect the
connectors (see section 9).
33. Top up the oil level in the housings. Check it using
the gauge at the rear of the centre housing.
34. Assemble the tractor between the engine and the
gearbox (see section 2).
35. Carry out a road test of the Power Shuttle and high
and low Speedshift ranges.
36. Check tightness of mating faces of the selector
cover (if necessary), the spacer (4) and the
hydraulic unions.
05B02.8
(Fig. 9), without forcing
MA-05-06014A
Massey Ferguson 5400 - Issue 1.a
1
Fig. 9