Table of Contents
Advertisement
C . 2-speed PTO (without shimming)
Disassembly
1. Remove the linkage and 3rd point support (see
chapter 6).
2. Remove
(Fig.
3):
- the trailer electric connector (1),
- the spool valve control cables (2),
- the hydraulic unions connected to the spool
valves (3),
- the trailer brake take-off (if fitted) and its support,
by loosening the unions at both ends.
3. Take out the spool valve support screws and
remove the spool valve support.
4. Disconnect the power take-off brake supply pipe
(1)
(Fig.
4).
5. Remove lubricating pipe (2)
6. Remove the 6 screws (3) and the cover (10)
(Fig.
4).
7. Take out the pinion assembly (13) and the shaft (2)
held in place by the washer (5) and the screw (6).
Take off bearing cone (4).
N
: The shaft (2) is fitted into the clutch (1) without
OTE
a locking screw.
Massey Ferguson 5400 - Issue 1.a
Intermediate shaft - Driving pinions - GPA20 brake
(Fig.
4).
Fig. 3
Fig. 4
07B01.7
Advertisement
Chapters
Table of Contents
