Embedded Dirtfinder™ Feature; Carrying Cleaner; Transporting Cleaner; Handle Positions - Hoover U5467900 Owner's Manual

2-3

Transporting cleaner

To move your cleaner from room to
room, put handle in upright position,
tilt cleaner back on rear wheels and
push forward.
2-6
A
B
Embedded DirtFINDER™
feature
(some models only)
With red and green lights (A), the 'Dirt
FINDER' system alerts the user to
areas of carpet that may need more
cleaning attention. It is able to sense
when larger amounts of dirt particles,
especially embedded dirt, are
removed.
To let you know that the 'DirtFINDER'
feature is ready, the red light will
2-7
B
Carpet height
adjustment
The cleaning of carpet and rugs
takes place at the nozzle (A).
When it is necessary to raise and
lower the nozzle for various carpet
pile heights, slide the nozzle control
knob (B) to the desired setting.
6
2-4

Carrying cleaner

The cleaner can also be moved by
using the carrying handle.
come on when the cleaner is first
turned on. After a few seconds, the
red light will go off and the green
light will come on. Cleaning may
then begin.
The green light will remain on
throughout cleaning except when
the detector senses that a larger
amount of dirt is being picked up;
then the red light will come on.
When the red light is on, you should
take additional cleaning strokes in
the area until it changes to green.
•The red light may seldom come on
during cleaning. This means that
your cleaner is picking up primarily
fine surface dust and lint which the
system may not detect, or that the
carpet is generally clean. To
increase the feature's sensitivity to
dirt, set the switch (B) to the "Hi"
position.
•At other times, the red light may
stay on for a considerable amount of
2-8
A
Handle position
For ease in sliding knob, the handle
should be in the upright position (C).
The nozzle will not move into the
adjusted position until the cleaner
handle is lowered to the operating
position (D).
C
D
2-5

Handle positions

The handle of your cleaner has three
positions; upright for storage and
when using cleaning tools; operating
position for general operation on
carpet and floors; low for reaching
under low furniture. Step on handle
release lever to lower handle.
time. This means that the carpet
contains a high level of dirt which is
being removed by the cleaner. To
decrease the feature's sensitivity to
dirt, set the switch to the "Reg."
(Regular) position.
2-9
HIGH

Settings

For maximum cleaning perfor-
mance, the following carpet height
settings are recommended:
• Lowest setting: for all types of
carpet
Note: If the cleaner is difficult to
push, slide knob to the next higher
setting.
• Higher settings: for very deep
pile carpet where easier pushing
effort is desired, while maintaining
good cleaning performance.
BARE
FLOOR