JVC KD-SH9101 Service Manual page 8

3.1.3 Removing the mecha control board
(See Fig.7)
• Prior to performing the following procedures, remove the top
chassis.
(1) Disconnect the card wire from the connector CN601 on the
mecha control board.
(2) Remove the five screws G attaching the mecha control
board.
(3) Release the joints a and b, remove the mecha control
board.
3.1.4 Removing the CD mechanism assembly
(See Fig.8)
• Prior to performing the following procedure, remove the top
chassis.
(1) Remove the three screws H from the inside of the top chas-
sis and remove the CD mechanism assembly.
1-8 (No.49841B)
Mecha control board
a
Fig.7
Top chassis
H
CD mechanism assembly
Fig.8
G
CN601
b
G
H
H