Table of Contents
Advertisement
¡ Transit bolts
→ "Removing the transit bolts",
Page 13
¡ Cover caps
¡ Elbow for securing the water outlet
hose
4.3 Requirements for the in-
stallation location
Note: Observe the information on
safety → Page 4 and preventing ma-
terial damage → Page 10.
WARNING
Risk of electric shock!
The appliance contains live parts.
Touching live parts is dangerous.
Do not operate the appliance
▶
without a cover cap.
WARNING
Risk of injury!
When using the appliance on a base,
the appliance may tip over.
Always secure the feet of the appli-
▶
ance to a base using the manufac-
turer's fixing brackets → Page 42
before using the appliance for the
first time.
ATTENTION!
The appliance may contain residual
water. If you tilt the appliance beyond
40°, this residual water may leak out.
Tilt the appliance carefully.
▶
Installation loca-
tion
Base
Requirements
Secure the appli-
ance with fixing
brackets
→ Page 42.
Installation and connection en
Installation loca-
tion
Wooden joist
floor
Kitchen unit
ATTENTION!
Freezing residual water Freezing re-
sidual water may damage the appli-
ance and frozen hoses may burst.
Do not install the appliance out-
▶
doors or in areas where there is a
risk of frost.
4.4 Removing the transit
bolts
The appliance is secured for trans-
portation using transit bolts on the
rear of the appliance.
Notes
¡ Observe the information on safety
→ Page 4 and preventing material
damage → Page 10.
¡ Keep the transit bolts, screws and
sleeves in a safe place for future
transport → Page 74.
Requirements
Place the appli-
ance on a water-
resistant wooden
board (minimum
thickness of
30 mm) which is
screwed tightly to
the floor.
Only install the
appliance under-
neath a continu-
ous worktop that
is securely con-
nected to adja-
cent cabinets.
Required niche
width: 60 cm.
13
Advertisement
Table of Contents
