Troubleshooting - Kohler S300 Installation And Homeowners Manual

B. Time Setting
!
Under the heater mode, there is a delay of 30 secs after
the heater mode is stopped or switched ventilation mode.
Fan light flashes while air flow light is on within the 30
secs of delay.
!
Under the fan mode, there is a delay of 3 secs after the
fan mode is stopped or switched to heater or ventilation
mode.
!
Under the ventilation mode, there is a delay of 3 secs
after the ventilation mode is stopped or switched to heater
or fan mode.
!
The defaulted duration time of heater, fan and ventilation
mode is 2 hrs.
C. Pairing Setting
!
Press ventilation and air flow for 2 secs within 3 minutes
after turning on power.
!
Pairing is successful after a beeping sound.
* The host of this product and the Wall Controller Assy have
been set and paired. Each host is packaged with a Wall
Controller Assy. Do not confuse the host with the wall
mounted switch during installation and removal. Avoid pairing
again.

TROUBLESHOOTING

Problem
Bathroom heater does not
work.
Wall controller break down.
1369766-T01-E
Diagnosis
A. Power failure.
B. Disconnected power cord.
C. Circuit breaker is off .
A. The pilot lamp does not turn on.
B. Fail to control the bathroom heater.
C. Fail to control the bathroom heater.
A.
B.
C.
A.
B.
C.
B.
!
" "
30
!
" "
" 3
!
" "
" 3
!
" " " "
C.
!
3
2
!
*
A. Wait until the power is restored.
B. Connect the power cord into the junction box
of bathroom heater properly.
C. Turn on the power at the breaker.
A. Ensure the wall controller is powered.
B. Ensure the heater is powered.
C. Pair the heater again.
A.
B.
C.
A.
B.
C.
-10-
"
30
"
"
" 2
Solution
"
" "
" "